Full Ramp 18-22mm

The profiles are quick and simple to fit, whether you are a seasoned carpenter or a DIY beginner. Follow the steps below, ensuring that you start with a clean and clear environment and the correct profile has been selected; 1, Trim down the profile and base to the desired length (if necessary). Be sure to double check measurements before cutting! The top profile may also need notching out in the corners to get a neat fit with the door frame. 2, Screw and/or glue the base section to the substrate surface between the two floors (or floor and wall) that are being covered or edged. 3, Allow the base an hour or so to settle and then simply tap the top profile into place with a rubber mallet. Adhesive can be added into the channel before fixing, for extra strength

Height Adjustable Base

The original and the best. All Parallel two part profile systems have an adjustable base profile which makes fitting a breeze. The principle behind a height adjustable base section is simple, it negates the need to have hundreds of individual profiles to do the same job but with slightly thicker or thinner floors. With our system, pick the base section that best suits the thickness of your floor and the top section takes care of itself. Once the base is correctly laid in the channel between your floors, the top section is tapped in from above and automatically self levels to the lowest point. In addition, because the profile is equally secure either at the top or bottom of the base section, it is not critical that the floor is 100% level from one end to the other.